Maintenance, Service, and Repair
Transmission Page 10
Installation
6. Lift the rear of the vehicle high enough to roll the transmission under the vehicle.
Always use a lifting strap,
hoist, and jack stands, of
adequate capacity to lift and
support the vehicle. Failure to
use lifting and support devices
of rated load capacity may
result in severe bodily injury.
12. Remove the four u-bolts holding the transmission
to the left and right springs.
13. Remove the lower bolt from the left and right spring
hangers.
14. Lift the rear of the vehicle high enough to roll the
transmission out from under the vehicle.
15. Place the frame of the vehicle on jack stands.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
To Next Page
