Maintenance, Service, and Repair
Batteries Page 6
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
CHARGING
Refer to Charging Your Vehicle in section Safety Rules and Operating Instructions.
6. Clean the batteries. Refer to Cleaning the
Batteries section for information on cleaning the
batteries.
7. Check the electrolyte level in all battery cells. If
low, fill to the correct level with distilled water using
part number 77-201-00 battery filler, never add
additional battery electrolyte to the batteries.
8. Reconnect the batteries, remove the blocks from
the wheels and test drive.
To Next Page
Loading...
