How to increase overrun in Taylor 220?
If the overrun is too low in your Taylor Freezer, adjust the temperature control accordingly. If that doesn't solve the issue, place the control switch in the AUTO position to blend in more air until the desired overrun is achieved. Also, ensure you are following proper priming procedures.
Why is product not freezing in Taylor Freezer?
If the product is not freezing in your Taylor Freezer, clean the condensers regularly. Make sure the control switch is in the AUTO position. If you have a water-cooled unit, ensure the water is turned on and check hoses for leaks or kinks.
What causes a stuck drive shaft in Taylor Freezer?
If the drive shaft of your Taylor Freezer is stuck, replace the drive shaft, drive socket, or both if the corners are rounded. Do not lubricate the hex end of the drive shaft.
What causes scored walls in Taylor 220 Freezer cylinder?
If the walls of the freezer cylinder in your Taylor Freezer are scored, ensure the scraper blades were installed properly.
Why won't the beater motor run in BEATER mode on Taylor 220?
If the beater motor will not run in the BEATER mode on your Taylor Freezer, repair any loose or broken wires at the beater motor contactor. If the wiring is intact, replace the contactor.
To Next Page
General
