21
Models 104 & 220
Troubleshooting
Model 220 (Cont’d.)
PROBLEM PROBABLE CAUSE REMEDY
9. Excessive mix leakage in the
rear drip tray.
a. Drive shaft seal is worn or
missing.
a. Install or replace the seal.
b. Inadequate lubrication of drive
shaft seal.
b. Lubricate properly.
c. Rear shell bearing is worn. c. Replace the rear shell bearing.
d. The wrong type of lubricant is
being used.
d. Use Taylor Lube.
10. No ejection. a. Unit is off on high head PSI. a. Allow the unit to cool.
b. Loose or broken wire at beater
relay.
b. Repair.
c. Defective rocker switch. c. Replace switch.
d. Defective door switch. d. Replace switch.
11. Overrun is too high. a. Not enough mix is in the
freezing cylinder when priming
the machine.
a. Follow priming procedures.
b. The temperature control is set
too warm.
b. Adjust accordingly.
c. Left in EJECT position too long
after drawing some product out
to place in hardening cabinet.
c. After drawing out the first
portion, place the control switch
in the OFF position. Return to
freezer to draw out more
product, place control switch in
the EJECT position.
12. Overrun is too low. a. The temperature control is set
too cold.
a. Adjust it accordingly.
b. Not enough air is blended into
the product.
b. Place the control switch in the
AUTO position to blend in more
air. Continue blending until the
desired overrun is achieved.
c. Improper priming procedures. c. Follow priming procedures.
12. Buzzer does not sound when
the freezer cycles off.
(Note: The buzzer is an optional
feature.)
a. Buzzer is malfunctioning. a. Replace the buzzer.
To Next Page
Loading...
Need help?
General
