What to do if Taylor 220 has no ejection?
If your Taylor Freezer is not ejecting, allow the unit to cool if it is off on high head PSI. Also, repair any loose or broken wires at the beater relay. If the wiring is intact, replace the rocker switch or the door switch.
How to improve poor ejection in Taylor 220?
If you're experiencing poor ejection with your Taylor Freezer, try using less time to run the batch to avoid over-refrigeration. If that doesn't work, increase the pre-charge. Also, ensure the beater is rotating clockwise.
Why won't the compressor run in AUTO mode on my Taylor 220 Freezer?
If your Taylor Freezer compressor will not run in the AUTO mode, repair any loose or broken wires at the compressor contactor. If the wiring is intact, replace the contactor.
What causes the beater motor not to run in AUTO mode on a Taylor 220?
If your Taylor Freezer beater motor will not run in the AUTO mode, repair any loose or broken wires at the beater motor contactor. If the wiring is intact, replace the contactor.
How to fix excessive mix leakage in the rear drip tray of Taylor 220?
If there is excessive mix leakage in the rear drip tray of your Taylor Freezer, install or replace the seal on the beater drive shaft. If that doesn't solve the issue, replace the bearing, and make sure to lubricate properly.
Why is my Taylor 220 unit off on high head?
If your Taylor Freezer is off on high head, replace the condenser fan if it is defective. Clean the condenser if it's dirty, and ensure there's at least 6” of air clearance around all sides of the unit.
What to do if my Taylor 220 Freezer product is not freezing?
If the product is not freezing in your Taylor Freezer, ensure the timer control is properly set or replace it if defective. For air-cooled units, clean the condensers monthly. Also, make sure the control switch is in the AUTO position for compressor operation.
Ensures safe installation practices and compliance with local codes and safety standards.
Guidelines for selecting a suitable installation location, considering ambient conditions and safety hazards.
Details on proper electrical hookup, grounding, and compliance with national and local codes.
Comprehensive safety warnings and procedures for operation, maintenance, and general handling of the unit.
Step-by-step instructions for assembling the freezer parts after cleaning.
Procedure for cleaning and sanitizing the unit using approved solutions and steps.
Steps for priming the freezer with fresh mix before the first batch.
Instructions on how to dispense the finished frozen product into containers.
Detailed steps for thorough cleaning and sanitizing of the unit.
To Next Page
General
