Taylor 428 - Page 27

OPERATING PROCEDURES
6-7
Model 428
Operating Procedures
6
j. Self-Closing Door Assembly
Place the O-ring onto the prime plug and
lubricate.
Figure 6-26
k. Self-Closing Door Assembly
Screw the prime plug into position on the front of
the door.
Figure 6-27
l. Self-Closing Door Assembly
Place the large rubber gasket into the groove on
the back side of the freezer door.
Figure 6-28
m. Self-Closing Door Assembly
Slide the white plastic front bearing onto the
bearing hub, making sure the flanged end of the
bearing is resting against the freezer door. Do not
lubricate the door gasket or front bearing.
Figure 6-29
11389
Apply the appropriate
Taylor approved food safe lubricant.
101690
101691