Taylor 60 - Operators Checklist; During Cleaning and Sanitizing; Troubleshooting Bacterial Count; Regular Maintenance Checks

33
Models 60 & 62 Troubleshooting Guide
150626
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
8. The freezing cylinder walls
are scored.
a. The scraper blades and/or
blade clips are damaged.
a. Replace the scraper
blades and/or clips.
14
b. Unit was placed in AUTO
before all sanitizing
solution was removed
from freezing cylinder .
b. Place unit in AUTO only
after priming is complete
and all sanitizing solution
is removed.
19
c. The front bearing is
missing or worn on the
freezer door.
c. Install or replace the front
bearing.
16
d. The beater assembly is
bent.
d. Call service technician to
repair or replace the
beater and to correct the
cause of insufficient mix in
the freezing cylinder .
---
e. Broken beater pins. e. Call service technician to
repair or replace.
---
9. Drive shaft stuck in gear
box coupling.
a. Lubrication on hex end of
shaft.
a. Call service techician for
removal.
---
b. Rounded corners of hex
end of drive shaft.
b. Replace defective drive
shaft.
---
c. Rounded corners of
coupling on gear box.
c. Call service technician to
replace gear box.
---
10. Excessive leakage of mix
into rear drip pan.
a. Worn or missing seal on
drive shaft.
a. Replace every 3 months. 35
b. Inadequate lubrication of
drive shaft.
b. Follow lubrication
procedures in “Assembly”.
13
c. Bad rear shell bearing. c. Call service technician to
replace rear shell bearing.
---
d. Drive shaft and beater
working forward.
d. Call service technician. ---
11. Machine will not operate
when control switch is in
“AUTO”.
a. Draw arm not raised. a. Raise draw arm
momentarily to activate
system.
20
b. Beater motor out on reset. b. Reset freezer. 12
c. Circuit breaker off. c. Turn breaker on. ---
d. Water turned off (water
cooled units).
d. Re- establish water
supply.
---
e. Power cord unplugged. e. Plug cord into wall
receptacle.
---