Taylor 8756 User Manual

5-2
USER INTERFACE
Model 8756
User Interface
5
Symbol Definitions
To better communicate in the international arena, the
words on many of our operator switches and buttons
have symbols to indicate their functions. Your Taylor
machine is designed with these international symbols.
The following chart identifies the symbol definitions used
on the operator switches.
= AUTO
= ON
= OFF
= MIX Refrigeration Control (Ref)
= WASH
= PUMP
= STANDBY
= MIX LOW
= MIX OUT
Power Switch
When placed in the ON position, the power switch allows
Softech™ control panel operation.
Indicator Lights
MIX LOW
When the MIX LOW light begins to flash, the mix tank
has a low supply of mix and should be refilled as soon as
possible.
MIX OUT
When the MIX OUT light begins to flash, it indicates the
mix tank has been almost completely exhausted and has
an insufficient supply of mix to operate the freezer. At this
time, the Standby and Auto modes are locked out and the
freezer shuts down. To initiate the refrigeration system,
add mix to the tank and press the AUTO key. The freezer
will automatically begin operation.
RESET Button
The RESET button is in the decorative plate above the
Softech controls. The reset protects the beater motor
from an overload condition. If an overload occurs, the
reset mechanism will trip. To properly reset the freezer,
press the AUTO button and cancel the cycle. Turn the
power switch to the OFF position. Press the RESET
button firmly. Return the power switch to the ON position.
Press the WASH button and observe the freezer’s
performance. Open the side access panel to check if the
beater motor is turning the driveshaft clockwise (from the
operator end) without binding.
When it’s turning properly, press the WASH button to
cancel the cycle. Press the AUTO button to resume
normal operation. Press the AUTO button on both sides
to resume normal operation. If the freezer shuts down
again, contact a Taylor service technician.
MIX Ref
When the MIX Ref button is pressed, the mode indicator
will light to indicate that the mix cabinet refrigeration
system is operating. There are two touch-tone panels,
one for each freezing cylinder. The mix refrigeration
system is controlled by the MIX Ref button found on the
left panel. When the AUTO button is pressed on either
side of the freezer, the MIX Ref function is automatically
activated. The MIX Ref function cannot be canceled
unless the Auto mode is canceled first.
STANDBY
During long no-sale periods, it becomes necessary to
warm the product in the freezing cylinder to
approximately 35°F to 40°F (1.7°C to 4.4°C) to prevent
overbeating and product breakdown.
When the STANDBY button is pressed, the indicator light
will come on, indicating the cylinder temperature
retention system (CTR) has been activated. In the
Standby mode, the Wash, Pump, and Auto functions are
automatically canceled. The Mix Ref function is
automatically locked in to maintain the mix in the cabinet.
To resume normal operation, press the AUTO button.
When the machine cycles off, the product in the freezing
cylinder will be at serving viscosity.

Taylor 8756 Specifications

General

Brand	Taylor
Model	8756
Category	Ice Cream Maker
Language	English