Taylor 8756 User Manual

Section 8
8-1
Model 8756
Troubleshooting Guide
8
Troubleshooting Guide
Table 8-1
Problem Probable Cause Remedy
Page
Ref.
1. No product is being
dispensed.
a. Low on mix. The MIX OUT light is
on.
a. Add mix to the mix tank and press the
AUTO button.
6-12
b. The power switch is in the OFF
position.
b. Place the power switch in the ON
position and press the AUTO button.
- - -
c. The beater motor is out on reset. c. Reset the freezer. 5-1
d. The beater assembly is rotating
counterclockwise.
d. Contact Taylor service technician to
correct rotation to clockwise.
- - -
e. Insufficient mix in the freezing
cylinder.
e. Go to problem 2.
- - -
f. Restriction in the door spout. f. Disassemble and clean the freezer.
Never put objects or fingers in the door
spout.
- - -
g. Circuit breaker is off or the fuse is
blown.
g. Turn the breaker on or replace the fuse.
- - -
h. The mix probe was not installed
properly or was damaged.
h. Check the mix probe installation.
6-13
i. The beater assembly is rotating
counterclockwise.
i. Contact a Taylor service technician to
correct the rotation to clockwise.
- - -
2. Insufficient mix in the
freezing cylinder.
a. Suction line is not fully submerged
in the mix.
a. Arrange the suction line so the weighted
end is fully submerged.
6-6
b. Improper seal of suction line to the
mix inlet fitting.
b. Remove the suction line from the mix
inlet fitting. Place under hot running
water, allow tubing to swell, then cool.
Connect suction line to barbed fitting.
Eventual replacement will be necessary.
- - -
c. Worn or defective check bands or
O-rings in air/mix pump assembly.
c. Replace regularly. Never lubricate check
bands.
6-6/9-1
d. Missing, defective, or no lubrication
on the mix inlet fitting 
O-ring.
d. Replace or evenly lubricate the O-ring on
the mix inlet fitting. 6-13/9-1
e. The pump motor is not activated. e. Place the power switch in the OFF
position. Push the reset button on the
pump drive motor. Return the power
switch to the ON position. Press the
AUTO key.
- - -
f. Pressure switch diaphragm
installed incorrectly or missing.
f. Diaphragm must be correctly installed in
the pressure switch cap.
6-9
g. The mix inlet tube is frozen or
clogged.
g. Use the long, flexible brush and
sanitizing solution to clear the restriction
in the mix inlet tube. Contact a Taylor
service technician to correct the cause of
over-refrigeration in the mix cabinet.
- - -
h. The mix pump ball crank is broken. h. Contact a Taylor service technician to
replace the ball crank.
- - -
i. Defective air/mix pump pressure
switch.
i. Contact a Taylor service technician to
replace the pressure switch.
- - -

Taylor 8756 Specifications

General

Brand	Taylor
Model	8756
Category	Ice Cream Maker
Language	English