Taylor 8756 - Parts Replacement Schedule

Section 9
9-1
Model 8756
Parts Replacement Schedule
9
Parts Replacement Schedule
Table 9-1
Part Description Every 3 Months Every 6 Months Annually
Scraper Blades X
Driveshaft Seal X
Freezer Door Gasket X
Front Bearing X
Beater Shoes X
Draw Valve O-rings X
Prime Plug O-rings X
Air/Mix Pump O-rings X
Check Band X
Mix Inlet Fitting O-ring X
Pressure Switch Diaphragm X
Design Cap X
Black Bristle Brush, 1” x 2” Inspect and replace if
necessary.
Minimum
Double-Ended Brush Inspect and replace if
necessary.
Minimum
White Bristle Brush, 1” x 2” Inspect and replace if
necessary.
Minimum
White Bristle Brush, 9/16” x 44” Inspect and replace if
necessary.
Minimum
White Bristle Brush, 3” x 7” Inspect and replace if
necessary.
Minimum
Small White Bristle Brush, 1/8” Inspect and replace if
necessary.
Minimum
Brush Set Inspect and replace if
necessary.
Minimum