To Next Page

To Previous Page

Models C709 & C717 Operating Procedures

080227

Brush Cleaning

Step 1

Prepare an approved 100 PPM cleaning solution

(examples: 2-1/2 gal. [9.5 liters] of Kay-5R or 2

gal. [7.6 liters] of Stera-SheenR). USE W ARM

WATER AND FOLLOW THE MANUFACTURER'S

SPECIFICATIONS. Make sure all brushes provided

with the freezer are available for brush cleaning.

Step 2

Remove all o-rings.

Step 3

Thoroughly brush clean all disassembled parts in the

cleaning solution, making sure all lubricant and mix

film is removed. Be sure to brush all surfaces and

holes, especially the draw valve hole in the freezer

door.

Step 4

Rinse all parts with clean, warm water. Place the

parts on a clean, dry surface to air dry overnight.

Step 5

Return to the freezer with a small amount of

cleaning solution. Using the black brush, clean the

rear shell bearing at the back of the freezing

cylinder.

Figure 53

Repeat these steps for the other side of the

C717.

Step 6

Wipe all exterior surfaces of the freezer with a clean,

sanitized towel.

Taylor C717 Original Operating Instructions

Other manuals for Taylor C717