To Next Page

To Previous Page

Models C709 & C717 Operating Procedures

080227

Step 2

Slide the two o-rings into the grooves of the outer

feed tube.

Figure 34

Step 3

Slide the small o-ring into the groove of the air

orifice.

Figure 35

Note: Make sure the hole in the air orifice is clean

and is not clogged. If the hole in the air orifice should

become clogged, use soap and hot water to clear

the hole. Do not enlarge the hole in the air

orifice.

Step 4

Lay the inner feed tube, the outer feed tube, and the

agitator in the bottom of the mix hopper for

sanitizing.

Figure 36

Repeat Steps 1 through 4 for the other side of

the C717.

Sanitizing

Step 1

Prepare an approved 100 PPM sanitizing solution

(examples: 2- 1/2 gal. [9.5 liters] of Kay- 5R or 2

gal. [7.6 liters] of Stera- SheenR). USE WARM

W ATER AND FOLLOW THE MANUFACTURER’S

SPECIFICATI ONS.

Step 2

Pour the sanitizing solution over all the parts in the

bottom of the mix hopper and allow it to flow into the

freezing cylinder.

Figure 37

Note: You have just sanitized the mix hopper

and parts; therefore, be sure your hands are

clean and sanitized before going on in these

instructions.

Taylor C717 Original Operating Instructions

Other manuals for Taylor C717