4
WARNING! All repairs must be performed by
an authorized Taylor service technician. The main power
supplies to the machine must be disconnected prior to
performing any repairs. Failure to comply may result in
equipment damage or personal injury.
These grills are designed for indoor use only.
Note: Only instructions originating from the factory or its
authorized translation representative(s) are considered to
be the original set of instructions.
IMPORTANT! This machine is provided with
an equipotential grounding lug that is to be properly
attached to the rear of the frame by the authorized
installer. The installation location is marked by the
equipotential bonding symbol (5021 of IEC 60417-1) on
the removable panel and the frame.
WARNING! Avoid injury.
• DO NOT operate this machine unless it is
properly grounded.
• DO NOT operate this machine with larger fuses
than specified on the data label.
• DO NOT operate this machine unless all service
panels and access doors are attached with
screws.
• All repairs must be performed by an authorized
Taylor service technician.
• The main power supplies to the machine must
be disconnected prior to performing any repairs.
• Only authorized Taylor service technicians or
licensed electricians may install a plug or
replacement cord on this machine.
• Stationary machines which are not equipped
with a power cord and a plug or other device to
disconnect the machine from the power source
must have an all-pole disconnecting device with
a contact gap of at least 1/8 in. (3 mm) installed
in the external installation.
• Machines that are permanently connected to
fixed wiring and for which leakage currents may
exceed 10 mA, particularly when disconnected
or not used for long periods, or during initial
installation, shall have protective devices such
as a GFI to protect against the leakage of
current installed by the authorized personnel to
the local codes.
• Supply cords used with this machine shall be
oil-resistant, sheathed flexible cable not lighter
than ordinary polychloroprene or other
equivalent synthetic elastomer-sheathed cord
(code designation 60245 IEC 57) installed with
the proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals
and protect the insulation of the conductors from
abrasion.
If the supply cord is damaged, it must be
replaced by the manufacturer, service agent, or
similarly qualified person, in order to avoid a
hazard.
Failure to follow these instructions may result in severe
injury or death from electrocution.
WARNING! This machine must be isolated
from all combustible construction and materials including
but not limited to walls, partitions, furniture, floors,
curtains, paper, boxes, and decorations. Failure to
comply may result in fire and cause destruction and
severe injury.
WARNING! For your safety DO NOT store or
use gasoline or other flammable vapors or liquids in the
vicinity of this or any other machine. Failure to comply
could result in a fire hazard.
IMPORTANT!
• DO NOT obstruct the ventilation openings at the
rear of this machine.
• DO NOT obstruct the flow of air in and around
the machine.
• DO NOT operate this machine unless all service
panels and access doors are attached with
screws.
Failure to comply may result in personal injury from gas
or electrical components.
To Next Page
Loading...
Need help?
General
