Energier Apollo User Manual
27
5.2.1 Power backup mode
When switch to “on”, the product is fully functional. The inverter will come into operation and the
display panel will light up.
5.1 Main switch（on/off）
5. Operation
In case of voltage/frequency/waveform of AC input matches the minimum quality, Energier Apollo
powers the loads via bypass.
If the “AC charger” is enabled, it will charge the battery from AC input source at the same time.
In case of AC input failure or exceeding the minimum requirement, Energier Apollo will initiate a
quick switching to inverter mode (less than 10ms), of which will guarantee an undisturbed power
for majority of the appliance. The LED “inverter” will light up to indicate the situation.
Energier Apollo has built in with power backup and solar mode working mode. The default working
mode is power backup mode.
Upon AC input is resumes and matches the quality requirements, it will switch back to bypass
mode automatically within 10ms.
5.2.2 Solar mode
Under solar mode, you can use Energier Apollo to compose a solar hybrid system, of which solar
energy will be used as priority and will bring grid/D.G. in and meantime charge battery upon battery
runs to protection level.
Solar is the first priority for the energy source. It powers the loads and charges the battery.
The battery energy is the supplement when solar energy is not sufficient.
When battery drops to the “inverter to grid” threshold, it brings AC grid/D.G in to power on the loads.
Only when the “AC charger” is enabled, it will charge the battery from the AC input source.
5.2 Working mode
To Next Page
Loading...
Need help?
General
