● Improving the antenna gain on the receiver end is better than increasing the output power (except
in RF-noisy areas). More tx power causes more issues with RF on your plane. 500mW is plenty of
power!
● Try to achieve as much separation of the VTx and R/C receiver as possible to lower the RF noise
floor and EMI interference.
● Do not buy the cheapest equipment unless it is proven to work reliably (e.g. parts falling off,
multitudes of bug fix firmware updates, community hacks and mods are a good indicator of poor
quality and something you do NOT want to buy for a safe system). Do due diligence and some
research before sending your aircraft skyward.
Manual written and designed by ivc.no in cooperation with TBS.
To Previous Page
Loading...
