TC Electronic Finalizer Service Manual

__________________________________________________________________________________________________________________________________________________________________________________________________
TC Electronic A/S Finalizer Service manual page 18
Software Changes:
Listed below are changes in the application software for the Finalizer.
Filename for application software is FINvxxx.wiz (xxx represents the version no.)
Changes from version 1.05 to 1.08:
Updating from 1.05 to 1.08 will not affect the presets.
1. exp range controllable by midi (now using #defines for number of exp
params)
2. threadSleep(2) inserted after midi exc dump head
3. handling “MAX 20 BITS”, “MAX 24 BITS” and “NONE - PROF”
(“16BIT” etc. changed to “16 BITS)”
4. no limit on rom/ram bank in output in dumpExclPreset() explicit return
in midiEndBulkSend() limit of midi values with 0x7f in dumpExclPars()
5. automatic re-initialization of the display implemented
6. accelerator on security PIN code
7. new compiler has reduced hi-shelve filter problem around 20kHz (no
more oscillation)
8. finv106 was with dspprobe, now Compare is back.
9. Analog gain before AD -2dB to compensate for AD error. Now analog
gain thru the unit should be close to 0dB.
10. Midi control (CTRL and SysEx) of MID and HI parameters in EXP,
COM and LIM block was not updated when changed from MIDI.

TC Electronic Finalizer Specifications

General

Brand	TC Electronic
Model	Finalizer
Category	Computer Hardware
Language	English