31
TOOLS Digital I/O (DIO)
IN
On this display you have various indicators that tell
you what kind of digital signal you are receiving.
Pre-emphasis
This parameter tells whether the incoming signal is pre-empha-
sized or not.
Source device (Category code).
The device status of the received signal is shown in this indicator.
Audio data
The number of received audio bits is indicated here.
Copyright (Copy inhibit).
Status of the copybits.
OUT
On this display you set up how the Finalizer should
send out your material.
COPY ENABLE
Set the copyrights of your material:
- No copies
- 1 copy only
- Infinite number of copies.
Note: The copy protection is only valid with S/PDIF signals.
STATUS BITS OUT
AES/EBU
When AES/EBU is selected the Finalizer will send out its own
professional set of status bits, meaning that any incoming ID will
be lost. However, in order to take full advantage of the
Finalizer’s 24 bit resolution you should select AES/EBU to make
sure that the receiving device after the Finalizer will accept all 24
bits.
S/PDIF
When S/PDIF is selected, the Finalizer will send its own con-
sumer status bits out, meaning that any incoming ID will be lost.
The Finalizer’s S/PDIF output carries up to 20 bits. Only the
S/PDIF signal contains copy protection information.
From Input
When this setting is selected the Finalizer will send the same
information out as it received. However, you still have the possi-
bility to change the copy status.
To Next Page
Loading...
Need help?
General
