TC Electronic Finalizer User Manual

8
REAR PANEL
Main
Power
Switch
Balanced
XLR
Inputs
Balanced
XLR
Outputs
Serial No.
AES/EBU
Digital
in/out
S/PDIF
Digital
in/out
MIDI
In,Thru,Out
Pedal/Fader
Input
NOTES:
To accommodate international regulations, we have also added a rear panel power switch.
You don’t need to use the power switch on the rear panel. Use the front panel power switch instead.
Pin 2 is »hot« on all XLR’s (IEC and AES standards).
If you are connecting the Finalizer to unbalanced equipment, you must tie pins 1 and 3 together in the cable
ends away from the Finalizer.
We have reserved the two unused pins on the MIDI connectors for an optional RS485 interface.
Therefore, if you are connecting the Finalizer to other equipment that use these pins, please make sure the
cable is a 3-wire standard MIDI type (not a five wire MIDIPLUS type).
If you want to use the pedal input, make sure it is a momentary »make« type.
Power
Input

TC Electronic Finalizer Specifications

General

Brand	TC Electronic
Model	Finalizer
Category	Computer Hardware
Language	English