TC Electronic Finalizer User Manual

32
WIZARD
Select source type: soft/medium/hard
Select degree of compression:
soft/medium/hard
Optimize gain
If this option is selected the Finalizer will adjust
the Normalizer level.
Press OK to start procedure
EQ
The Finalizer will adjust the Equalizer to the selected
spectral expression.
Wizard -
Making the whole thing very simple
Press the WIZARD key.
With the Wizard you set a couple of terms, and the Wizard will select the optimal settings for you: the Normalizer, Compressor, Limiter and
EQ.
Select whether your source type is soft, medium or hard, using the ADJUST wheel.
Select which kind of compression you like: Soft, medium or hard.
Do you want your material to be gain optimized? Yes or no.
Note: If you use auto-gain, the Wizard will be measuring until you stop it.
This means that you can run all of your material through the Wizard to get the optimum level.
Select which EQ setting you would like: Flat (no EQ), Loudness, Bass-lift or Air.
Press the OK key to carry out the settings of the Wizard.
Press any key to stop the Autogain function.

TC Electronic Finalizer Specifications

General

Bit Depth	24-bit
Type	Mastering Processor
Inputs	Analog XLR, Digital AES/EBU, S/PDIF
Outputs	Analog XLR, Digital AES/EBU, S/PDIF
Processing	EQ, Compression, Limiting, Stereo Enhance
Sample Rate	32 kHz, 44.1 kHz, 48 kHz