16
Stereo Setup
If you run your sound system in stereo, you can enable
stereo mode. In this setup, effect patches have more
spatial effect. In this configuration, the Left and Right
Outputs are connected to two inputs on your sound
system. The Mix Knob controls the balance of stereo
effects and dry.
Configuring Stereo Setup:
1. Connect your microphone to Create's Mic Input.
2. Connect to your sound system as indicated: Left
Output and Right Outputs to two mic input channels on
your sound system. Set the pan pots on your sound
system fully left (from Create's Left Input) and fully right
(from Create's Right Output).
3. Connect Create's power adapter to main power
and to the Power Input on Create.
4. Press and hold Performance Buttons 4 and 5
simultaneously until the Stereo Light comes on. To turn
stereo mode off, repeat this step.
Setup Configurations
To Next Page
Loading...
Need help?
General
