26
2. Select patch 21 - Mono Tap by turning the Patch
Knob until 21 is indicated on the Numeric Display.
3. Press & hold the Right Footswitch for two seconds.
The Effect On Light will flash the patch's stored tempo.
4. Tap the Right Footswitch in time with your song
(usually only a few beats are necessary) until you are
satisfied you've matched the tempo. The Effect On light
will continue to flash at the tempo you've entered. Press
and hold the Right Footswitch to exit tap mode.
μMod
μMod is short for micro-modulation ("μ" is the scientific
symbol for micro). The μMod effect is capable of
creating many different sounds that range from subtle
and unobtrusive to creatively destructive.The effect uses
a combination of stereo pitch shifting (Detune), small
amounts of stereo delay (Delay), and then a complex
path of filtering, feedback, and modulation. μMod does a
faithful job of emulating classic detune and thickening
sounds which have been common since the 60's.
However, often these effects don't get noticed by the
audience until they are turned off.What do get noticed
right away are the more extreme uses of μMod that
produce sounds that modulate over time.
μMod effects:
- Micropitch
- Detune
- Thicken
- Chorus
- Flanger
Effect & Genre Descriptions
If the Effect On Light is not flashing, or momentarily
flashes rapidly then stops, tap tempo is not available
for the patch you selected. Select another patch
from the Patch List that has tap tempo enabled.
NOTE:
Tap tampo is stored with each part when a
performance is stored.
NOTE:
To Next Page
Loading...
Need help?
General
