34
DVR Function
3. While in Time Shift mode, below operations can be use.
Press the
or button repeatedly to increases the fast forward/rewind
speed.
Press the
button to jump about 30 seconds forward.
Press the
button to jump about 30 seconds backward.
Press the
button to once to set the beginning point “A” and press the
button again to set the ending point “B”. Then the segment A-B will be played
repeatedly. Press the
button to cancel the repeat segment.
Recording program
After you setup the settings on the DVR File System menu, you can record a DTV program on the external
USB device.
1. Select the desired program then press the record
button on the remote control to start
recording and progress bar will be displayed.
During recording, the progress bar will fade out in 10 seconds.
Press the button again, an icon will blink on the bottom right corner of the screen
and it will fade out in 10 seconds.
2. Recording stops when you press the STOP button and the recorded file is stored in the external
USB device automatically.
3. Press the ►PLAY button to start to play the file fresh recorded.
Recording in standby mode
This unit is able to do recording while in sleep mode.
Start a recording, then press the power button.
A message as shown on the right will be displayed.
Select Yes to record in standby mode.
Select no to switch unit to standby.
While recording in standby mode, unit will not output any picture or sound. The power indicator will
flash in blue and red consecutively while there is a recording in standby mode.