33
Exiting Programming Mode
To exit from the programming mode, first ensure that the display indicates
you are in the main menu.
At this point, press to exit programming mode.
E
ENTER
The display will change to:
TEC 100 V3
ACTIVE
And then, after a few seconds to:
FIRING Tu 15:35
S57 F50 R42 E05
The display may show slightly different information depending on the
current mode of operation, i.e. boost, firing, economising etc.
Note: When in programming mode the TEC 100/200 will revert to
normal
running mode if the keypad is not operated for a period of 30
seconds (4 minutes if in program change mode).
To access programming mode from normal running mode:
Press and then select required program with .
Make any program changes as described previously.
P
PROGRAM SELECT RETURN
To Next Page
Loading...
