6 - Operation
Operating the MIO2
MIO2 Operating Manual, 394934, en, V3.0 6 - 3
6.3.3 Switching the Incubator On
Refer to the appropriate Software Application Manual for further instructions.
6.3.4 Switching Incubator Off
Refer to the appropriate Software Application Manual for further instructions.
6.3.5 After an Aborted Run
After a run has been aborted:
Check if a plate has been loaded into the incubator.
WARNING
Injuries or contamination with hazardous materials possible if the maintenance is
not carried out properly.
Make sure that the instrument worktable and the MIO2 are free from
hazardous materials. Decontaminate them (or have them decontaminated) if
necessary.
Use adequate protective clothing, goggles and gloves.
Make sure MIO2 has cooled down to room temperature before performing
maintenance tasks.
Make sure the incubator slots are empty before performing maintenance
tasks.
Refer to chapter 8 “Troubleshooting”, 8-1 for corrective measures
To Next Page
Loading...