9. Web Interface
The following pages outline the steps required to access the Technalogix Adrenaline Web Interface.
Descriptions specific to the user’s computer, router, or network setup are limited due to the differences
in the multitude of networking equipment.
1. Connect Power Amplifier/Transmitter to your Network/PC
Connect an Ethernet cable from the RJ45 port (labelled ETHERNET) on the back panel of the
power amplifier or transmitter to your network’s Ethernet connection. Most new computers can do
this with a standard Ethernet cable but older network cards may require a crossover Ethernet
cable.
If preferred in place of the screen, a computer can be plugged directly into the Ethernet port on
the power amplifier/transmitter to directly access the on-board web interface.
Turn on the transmitter to establish communication with the network.
The Adrenaline control system in the power amplifier or transmitter will source an internal IP from
your router or you can set this manually (see Optimize User Parameter section).
2. Open web browser for monitor and control
The default internal address is http://adrenaline/index.htm. Type this default internal address into
the URL address bar of your favorite web browser. The web pages cannot be accessed until you
have established basic communication with the transmitter (turned on).
2.1. Web Page Password Protection
After entering the above internal address into a web browser, you will be asked for a password.
Initially, please use the following:
username: admin
password: admin
The password can later be changed (see Optimize user parameters section).
To Next Page
Loading...