Technics RS-DC10

used.
i Toldnat=lMireial celan( Mel men(cit-\ie(-lel-t-mer- lel o\=)
Start playback.
The play indicator lights.
Loading an analog cassette tape
Load the cassette tape onto the cassette tray.
Place with side A facing up. —
Load the cassette with the
side where the tape is
exposed toward the deck.
Cassette tray
Analog Cassette Tape Playback
MODE
When the cassette tape has not been toaded properly, the
display shown below appears and the cassette tray opens’
automatically. Check the direction in which the cassette
tape was loaded, load it correctly and then close the
cassette tray.
(CASSETTE BLOCKED)
Removing the cassette tape
OPEN/CLOSE
Temporarily stopping playback
Move
PAUSE
(PAUSE)
The play indicator flashes.
Press the play button to
resume playback.
il
i it
i
i t
t
Stopping playback
STOP
--
The play indicator goes off.
Setting the Dolby NR system
The Dolby NR system can be used when playing
back analog cassette tapes.
This deck is equipped with Dolby type B and type C.
Select the same type of system that was used for
recording.
Set the Dolby NR selector to OFF when listening to a
tape which was not recorded using the Dolby NR
system.
About the Dolby Noise Reduction
system
Using Dolby NR reduces tape hiss in the
high-frequency range. It boosts the level of the
high-frequency program content during
recording, and lowers it by the same amount
during playback, simultaneously reducing
high-frequency noise incurred during the
recording process.
| Dolby noise reduction manufactured under
license from Dolby Laboratories Licensing
; Corporation. “DOLBY” and the double-D
| symbol [XJ are trademarks of Dolby
Laboratories Licensing Corporation.
Le ae Reeree