Technics RS-DC10

Concerning the Remote Control
Battery installation
1 va? 2
Open the cover.
equivalent batteries.
Insert the batteries included.
When you need to replace these batteries,
use two UM-4 “AAA”, IEC ROS (1.5 V). or
8
WAZ
i
Close the cover.
Use of batteries
Do not mix old and new batteries or batteries of
different types (carbon and alkaline, etc.).
Replace the batteries if commands from the remote
control transmitter do not operate the unit even when
the transmitter is held close to the front panel.
The average battery life is about one year. Although
the battery life varies depending on how often the
device Is used, you should generally replace the
batteries about once a year.
If you will not be using the remote control for a long
period of time, remove the batteries and store them in
a cool, dark place.
Operation notes
Deck’s
sensor
my
7 Transmission
window
About 7 meters in front
of the sensor
(The actual range will depend
on the angle at which the
remote control is used.)
Do not use rechargeable-type (nickel-cadmium) batteries.
Do not attempt to recharge alkaline or carbon batteries.
Never subject batteries to excessive heat or flame; do not
attempt to disassemble them: and be sure they are not
short-circuited.
Always remove old, weak, or worn-out batteries promptly
and dispose of them properly.
{f a battery leaks, remove all batteries and dispose of them
properly. Thoroughly clean the battery compartment
before inserting new batteries.
If the leaking electrolyte comes into contact with skin or
clothes, flush with water immediately.
Do not dispose of used batteries in household rubbish. heeded
Aim the remote control transmission window toward
the deck’s sensor. Avoid any obstacles.
Use the remote control within a 60-degree angle of
the deck.
The reachable distance is within 7 meters directly
facing toward the deck.
Be sure the transmission window and the deck’s
sensor are free from dust. Excessive dust might
prevent reception.
elf direct sunlight or other strong light source strikes the
remote control signal sensor part of the deck, it may impair
the remote control's operation. If there is a problem, place
the deck away from the light source.
lf the deck is installed in a rack with glass doors, the glass
doors’ thickness or color might make it necessary to use
the remote-control transmitter a shorter distance from the
system.