Technics RS-DC10

Analog Cassette Tape Playback
Playing back the tape repeatedly (repeat play)
In the case of analog cassette tapes, it is possible to
repeatedly play all the tracks on the tape but not a
particular track.
The following display
REPEar appears.
=e ‘ease.
CONT
REPEAT
Quick reverse function
This function serves to detect the leader tape section
and in about one second automatically change the
playback direction.
Magnetic section
Leader tape section.
Reieasing the repeat play function
The display changes to
what is shown below.
ee
REPEAT
This function becomes operational only when about
15 seconds have elapsed after the start of playback in
order to prevent the leader tape section at the beginning of
the tape from being detected. — pate ae
When quick reverse does not operate, the tape direction is
reversed at the end of the tape.
This function does not work with a tape which does not
have a leader section.
®This function may not work with tapes which have a
colored teader section, with dusty or dirty tapes or with a
thin magnetic layer.
Concerning analog cassette tapes
Selection of cassette tapes
Do not use the 120-minute (or longer) tapes in this
unit.
Tape slack
Use a pencil or
similar object to take
up the slack.
Because the tape js very thin, it might stretch during use,
causing unstable tape movement. This may result in the
tape becoming tangled In the rotating parts of the cassette
deck.
Tape slack may cause the tape to break.
Improper tape storage
You can damage tape if you store it in the following
ways:
1) In high temperature [95°F (35°C) or higher] or high
humidity (80% or higher) areas.
2) Ina strong magnetic field (near a speaker, on top
of a TV, etc.). This can erase a recording.
3) In direct suntight.