Technics RS-DC10

Analog connections
(@xeyalal=xeitie) ars)
aSeeeS AKALOG, DIGITAL
{ saaae
Analog output
connectors
Amplifier
(optional)
Connections to deck’s analog output connectors
This deck comes with two pairs of analog output
connectors. Use the accessory stereo connection
cable to connect a unit to one of these two palrs of
connectors.
Installation
Avoid locations nearby tuners or
television sets.
Since this unit uses high-frequency signals, placing it
near a tuner or television set may result in
interference with the tuner/TV reception. If this kind of
audio or video interference is experienced, move the
DCC unit away from other AV components.
Fixed output connectors (FIX)
Normally, these output connectors are used. When a
unit has been connected to them, the output level
cannot be adjusted by operating the accessory
remote controller.
Variable output connectors (VARIABLE)
Use these connectors when the output level is to be
adjusted using the accessory remote controller.
Since the same kind of phenomenon may occur when
an indoor antenna is used with the tuner or TV set,
use an outdoor antenna instead.