Technics RS-DC10

(Ore) alalsceiilevars
Be sure to turn off the power to all the components
before proceeding to connect them.
Connect the power cable only after ail the other
connections have been performed. a
Digital connections
There are two ways to perform the digital “~~
connections: elther connect a digital amplifier to the
deck or connect another digital component directly to
the deck,
An example of the connections is given below.
For further details, consult the Operating Instructions
of the components involved as well.
To connect optical fiber cables
@ Remove the dust cap @ Connect the cable.
from the terminal.
BB
Dust cap Align the terminal shape.
Do not attempt to bend optical fiber cables at severe
angles.
Be sure that connections are made securely.
About
Optical
Fiber
Cables
_
Optical fiber cable
(optional)
CD player or other
digital component (optional)
Digital direct recording
ACD player or other digital component can be
connected directly to the deck and the digital signals
of that component can be recorded without further
ado. (See “SCMS” on pages 60 and 61.)
Store the dust cap securely, and repiace it whenever cables
are not connected to the terminals. If dust is allowed to
enter the terminal connector, signal errors may result.
]
About OPTICAL connector
When the optical connectors are used, electrical
signals are converted Into light signais for
transmission between units, making the signals
impervious to adverse effects from external |
| noise. This form of connection thus allows the
highest quality of digital audio signal
| transmission. |