Technics RS-DC10

50) |
Digital Input Recording (DCC Tapes)
Recording from the start of a tape
Digital recordings can be made from CDs, DATs, or
the digital signals used in satellite broadcasts
received by a BS tuner.
Refer to page 38 when recording from midway
through a tape (append recording).
Upon completion of recording on side A, the recording
side is automatically switched to B and recording
continues.
1 INPUT SELECTOR Set the input
ANALOG |. OPTICAL
Preparations:
1. Check that the “accidental erasure prevention tab“
on the DCC tape for recording is set to the
recording position. (See page 11.)
2. Load the cassette tape. (See page 17.)
Technios — ocira compact cassarrd ofc ns-pci0
selector to one of
the “DIGITAL”
Inputs.
REW Check that the side to be
recorded on is side A, and
ea rewind the tape to
its beginning.
REC? Set the deck to the
3 recording standby
mode.
After the lead-in has been
written onto the tape, the
deck is set to the
recording standby mode.
This takes about
30 seconds.
(See page 32.)
The recording indicator
lights and the play
indicator flashes. The
input indicator lights.
Play indicator
Even if the tape is new, be sure to rewind it first so that the
absolute time will be written.
Do not operate any other button until the tape automatically
comes to a stop after rewinding.
peewee em eee
Writing the lead-in
Beginning of tape
Recording standby mode
-TRACK- 9 — THE COUNTER —— se ——