Technics RS-DC10

Marker Editing while Recording is in
Progress
Changing the tape side to record
(reverse marker)
Reverse marker
This is used to change from tape side A to side B ata References:
point midway through recording so that recording can eit is also possible to record a part of a track on side A and
be continued. It can be written only on side A. continue with the recording of the rest of the track on side
During playback, the tape side is automatically B. in this case, the track number is added.
switched at the position where the marker Is written. elt is a good idea to set the counter display to the display
indicating the remaining time on one side of the tape.
Example: When recording tracks 1 through 5 on side
A and then recording tracks 6 through 9 on
side B
@ Reverse marker
Side A |
Tape Track 1} Track 2 |Track 3]Track 4]Track 5
| Track 9 [Track 8[Track 7 | Track 6 —
Side B f
@ Tape is changed over to side B.
There are two ways of writing the reversé marker. —