Technics RS-DC10

0)
Marker Editing after Recording
Adding running numbers to the edited start
markers (renumbering)
Rewrite the track numbers at the start marker Preparation:
positions in sequence from the beginning of the tape Check that the “accidental erasure prevention tab” on
when the track sequence has been changed because the DCC tape for editing is set to the recording position.
start markers have been added or deleted. (See page 11.)
1
Technics para compact dhaserte ecw 8.009 = é
| .
Stop button
process
1 In the stop mode: Stopping the renumbering
Start renumbering sToP
the tracks.
ENUMBER
ne The tape is rewound to the
beginning of side A, the
start markers are Renumbering cannot be performed on tapes on which the
automatically searched, absolute time is not written.
and the tracks are Interrupt the renumbering operation and stop the tape.
renumbered in sequence Renumbering may not function property if the distances
starting from track 1. between start markers are too short.
Display which appears during renumbering
| -TRACK=
(RENUMBER)
The absolute time display is shown here.
When the renumbering of side A is completed, the
tape is automatically fast forwarded and the
renumbering of side B commences.
When, during renumbering, the tape arrives at the
position where the start marker was written, the track
number is checked, and if it is not written correctly, the
tracks are renumbered.
Upon completion of the track renumbering, the tape is
rewound to the beginning of side A and it stops.
The reverse marker, etc. will be written properly by
the renumbering process.
STRAT SES SRT