Technics SC-CH730 User Manual

EQ SPACE/
FLAT V.BASS
SOURCE
DIRECT
Amplifier
To retrieve the equalization curves and
simulated listening environments
Press EQ SPACE/FLAT to se-
lect the mode.
EQ SPACE/
FLAT Each time you press EQ SPACE/FLAT,
Cr] EQ and SPACE modes will be switched
as follows.
HALL—CLEAR->HEAVY-—> FLAT
aa ree Te ae
(7) HALL
Use to impart a deep bass and spread which will make you feel as if
‘you were in a large concert hall.
[2] CLEAR
Use to clarify the treble range of jazz, etc.
[3] HEAVY
Use to add “punch” to rock and other music.
¢You cannot record with HALL, CLEAR or HEAVY mode.
@"HALL”, “CLEAR” and “HEAVY” indicator light off while recording,
and light up when the recording finishes.
To listen with augmented bass (V. BASS)
Press V. BASS.
V.BASS Each time you press the button, the dis-
play will change as follows:
V. BASS 1-+V. BASS 2->OFF
Ro a
eV. BASS 2 is more effective than
V. BASS 1.
You cannot record with the V. BASS effect.
“V.
BASS”
effect
added
only
to
the
sound
heard
through
the
speakers
or headphones.
Amplifier
To obtain even higher quality sound
from a CD or other source
Press SOURCE DIRECT to ON.
SOURCE The SOURCE DIRECT indicator on the
DIRECT volume control lights up.
The sound signal will be transmitted with-
out passing through the graphic equalizer
and other circuits, thus providing even
higher quality sound.
To cancel the SOURCE DIRECT mode,
press the button again.
The SOURCE DIRECT indicator lights
off, and the FLAT mode is selected.
When this button is set to the “ON” position, any tonal effect (HALL,
CLEAR, HEAVY, V. BASS) and KARAOKE mode will be cancelled.
e@When you connect the microphone;
eWhile the SOURCE DIRECT mode is ON, the SOURCE
DIRECT mode will be cancelled and the FLAT mode is selected.
® You cannot switch on the SOURCE DIRECT mode.

Technics SC-CH730 Specifications

General

Brand	Technics
Model	SC-CH730
Category	Stereo System
Language	English