Operation & Maintenance Manual
CD-135 / CD-155
OM-02-02
Chapter:
Issue:
Issue date:
Page:
Content:
02-OM-07-02
4
30.07.2014
2
6
Revision no.:
Revision date:
-
-
7.3 Engine System Malfunction
7.3.1 One FADEC light flashing
1. Press FADEC test button at least 2 seconds
(refer to Chapter 4, Section 4.4.3, Page 7 of this Manual)
2. FADEC lights extinguished (temporary failure):
a) Continue flight normally
b) Inform service center after landing. The lights will
illuminate after the ignition has been switched off and
on.
3. FADEC lights steady illuminated (steady failure or high
category failure):
a) Observe the other FADEC lamp
b) Fly to the next airfield or landing strip
c) Select an airspeed according to the appropriate POH
d) Inform service center after landing
Note: The FADEC consists of two components that are independent of
each other: FADEC A and FADEC B. In case of malfunctions in
the active FADEC, it automatically switches to the other.
To Next Page
Loading...
