12
UNIT OPERATION
TURNING THE UNIT ON
When the AC power cord is connected, press the / I button on the unit
to turn it on. Press the FUNCTION button to select the desired mode (DTV,
TV, AV2/SCART, DVD, PC or AV1). If you select DVD, the DVD logo will
appear on the screen.
Note: When the unit is not going to be used for a long time, disconnect
the AC power supply cord from AC outlet.
TURNING THE UNIT ON FOR THE FIRST TIME
• MakesuretheRFaerialhasbeenconnectedtotheTVANTENNAinputontherearoftheTV.
• Make sure the CAM (Conditional Access Module) has been inserted into the CI (Common
Interface) slot correctly, if you are using a CAM.
The first time for you turn on the unit, initial setup menu will appear. You can simply follow the on
screen prompt to set up the system.
1. Use the / button to select the screen menu language you prefer.
2. Use the button to move to Auto Tuning, press the ENTER/OK button to enter Auto Tuning menu.
3. Use the / button to select the Country you are in.
4. Use the button to move to Start. Press the ENTER/OK button confirm Start. The system will
automatically start to scan and preset all available programmes.
5. After scanning has finished, the TV will display the first programme stored.
To Next Page
Loading...
Need help?
General
