Receipt of Equipment
When the equipment is received the outside packing case should be checked immediately for any shipping damage.
remove the unit from its packing case and inspect for damaged or missing parts.
If damage has occurred during shipment or parts are missing, a written report should be submitted to
the Customer Service Department, TechnipFMC Measurement Solutions, Inc., 1602 Wagner Avenue, Erie, Penn-
sylvania 16510.
Prior to installation, the unit should be stored in its original packing case and protected from adverse weather
conditions and abuse.
Caution
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with this Instruction Manual, may cause interference to radio communications. It has not
been tested to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15
of FCC Rules, which are designed to provide reasonable protection against such interference when
operated in a commercial environment. Operation of this equipment in a residential area is likely to cause
interference, in which case the user, at his own expense, will be required to take whatever measures may
be required to correct the interference.
Warning
These preset devices must be used with fail-safe backup equipment to prevent accidental runaway delivery
of product. Failure to provide backup equipment could result in personal injury, property loss and equipment
damage.
Warning
On initial power-up of a new unit or after installation of a new computer board, there are several alarms that will be
triggered, which cannot be cleared until the microLoad.net is programmed.
To Next Page
Loading...
Need help?
General
