8
Initial installation
When switching on the unit for the fi rst time, a start window will be displayed,
with the installation assistant AutoInstall. Please follow the instructions dis-
played on screen. If you do not implement the initial installation, or if it is not
completed, the receiver will commence operation with a standard pre-channeld
confi guration.
Antenna confi guration
In this installation step you can adjust the digital receiver to the confi guration of
your antenna.
> If you wish to accept the standard antenna setting, use the arrow keys
up/down to highlight the fi eld Standard and confi rm by pressing OK.
> If the confi guration of your receiving installation does not correspond
with the standard setting, highlight the fi eld Manual and confi rm by
pressing OK.
DiSEqC
> If you have DiSEqC components in your receiving installation, highlight
the fi eld Activate and confi rm by pressing OK
Position A/Option A
> Use the arrow keys up/down to highlight the satellite you wish to receive
at the DiSEqC setting Position A/Option A and confi rm by pressing OK.
Position B/Option A
> Use the arrow keys up/down to highlight the satellite you wish to receive
at the DiSEqC setting Position B/Option A and confi rm by pressing OK.
Position A/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive
at the DiSEqC setting Position A/Option B and confi rm by pressing OK.
Position B/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive
at the DiSEqC setting Position B/Option B and confi rm by pressing OK.
In the next step, you should check on the correct confi guration of your
antenna.
> If you wish to accept the settings entered, use the arrow keys up/down
to highlight the fi eld Yes, and confi rm by pressing OK.
To Next Page
Loading...
Need help?
General
