9
ENEN
Position A/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive
at the DiSEqC setting Position A/Option B and confi rm by pressing OK.
Position B/Option B
> Use the arrow keys up/down to highlight the satellite you wish to receive
at the DiSEqC setting Position B/Option B and confi rm by pressing OK.
In the next step, you should check on the correct confi guration of your
antenna.
> If you wish to accept the settings entered, use the arrow keys up/down
to highlight the fi eld Yes, and confi rm by pressing OK.
You can abort the initial installation at any time simply by pressing the red func-
tion key. Press the green function key to go back to the previous step in the
installation procedure. Thus any entries made incorrectly can be quickly cor-
rected. If you do not implement the initial installation, or if it is not completed,
the receiver will commence operation with a standard pre-channeld confi gura-
tion.
For daily use
Switching on and off
> Press the On/Standby key either on the digital receiver or the remote
control to switch the receiver on.
> Press the same key again to switch the receiver off.
Channel selection
Using the channel up/down keys
> Use the channel up/down keys on the remote control or on the receiver
to move up or down the list one channel slot at a time.
Using the numeric keys
> You may use the numeric keys to enter the desired channel number. For
example: 1 for channel 1
1, then 4 for channel 14
2, then 3, then 4 for channel 234
When entering a channel number consisting of several digits, you have ap-
prox. 3 seconds after pressing each number to complete the entry. If you wish
to enter a number consisting of only one or two digits, you can speed up the
switching procedure by holding the key down on the last digit.
To Next Page
Loading...
Need help?
General
