> Use the right / left arrow keys to select whether you have connected 1 or 2
DVB-S antenna signals.
> Confirm with the OK button to open the selection list.
Antenna configuration (DVB-S)
In this step of the installation, you can adapt your digital receiver setup to the configuration
of your antenna (DVB-S).
> If you want to accept the default antenna setting, press the OK button.
> If the configuration of your reception equipment does not conform to the default
setting, press the Options key.
> Now, as described in greater detail in Point 8.6 in your operating manual, apply the
appropriate antenna settings for your reception equipment and then press the Back
button to return to the antenna configuration overview.
> Then confirm with the OK button to accept the settings.
Antenna configuration (DVB-T)
When using an active DVB-T antenna that does not have its own power supply, or if you do
not want to use this, your receiver's antenna amplifier can be supplied via the coaxial cable
by activating the Antenna feed. To do so, set the antenna supply to.
24
To Next Page
Loading...
Need help?
General
