TechniSat DIGITRADIO 20 CD - Audio Stream; DAB+ (Digital Radio) Reception; Performing a Complete Scan

7.1.2 Audio stream
With digital radio, audio streams are continuous data streams which contain the
MPEG 1 audio layer 2 frames and thereby represent acoustic information. This
enables standard radio channels to be broadcast and listened to on the receiver
side. Digital radio provides you not only with excellent sound quality radio but also
additional information. This may refer to the programme being broadcast or be
independent information (e.g. news, weather, trac, tips).
7.2 DAB+ (digital radio) reception
> Press the MODE buon until [DAB] is shown on the display.
If DAB+ is being started for the first time, a complete scan will be performed.
In order to perform a complete scan, open the menu by holding down the
Info/Menu buon and use the Tune +/ - and Enter buons to select the menu
item [Complete Scan].
7.2.1 Performing a complete scan
The automatic scan (Complete scan) scans all DAB+ band III channels and
thereby finds all stations being broadcast within the reception area.
In order to perform a complete scan, open the menu by holding down the
Info/Menu buon and use the Tune +/ - and Enter buons to select the menu
item [Complete Scan].
> In order to perform a complete scan, open the menu by keeping the MENU
buon pressed and use the SCROLL&SELECT knob to select the menu item
[DAB Menü]. Press the SCROLL&SELECT knob to open the submenu.
> Using the SCROLL&SELECT knob, select the [Complete scan] menu item and
press it to launch the scan.
> [Scanning...] appears on the display.
Scanning...
During the scan a progress bar and the number of stations found is displayed.
If no stations are found, check the dipole antenna and change the installation
location if required (Section 4.3.3).
20