15
DAB Operation
Press the MODE button on the unit repeatedly or press the FM/DAB button on the remote control
to select “DAB radio”. (F.6) The unit will enter DAB mode and perform the auto scan function. During
the scan the display will show “Scanning… ” together with a slide bar that indicates the progress of
the scan and the amount of stations that have been found so far. (F.7) Once the scan has finished,
the unit will select the first alpha numerically found station. To explore the found stations, press the
PRESET buttons to select and press the ENTER button to confirm.
(F.6) (F.7)
DAB
radio
Scan
Stations:
0
S
canning
Station List
1.
During DAB mode, press the MENU button to access DAB menu.
2.
Press the PRESET buttons to select “Station List” and then press the ENTER button to
confirm.
3.
A list of DAB+ stations will show on the display.
Auto Scan
- Press the SCAN button to activate auto scan.
Alternatively,
- Press the MENU button, and then press the PRESET buttons to select SCAN. Press the
ENTER button to confirm.
1.
The display will show “Scanning…” and a progress slide bar.
2.
All the stations that have been found will be stored automatically. To explore and listen to the
found stations, press the PRESET buttons to select and the press the ENTER button to
confirm.
Manual Tuning
As well as the auto tune function, you can manually tune the receiver. This can help you when
aligning your aerial or when adding stations that were missed while auto tuning.
1.
Press MENU on the remote control to display the menu.
2.
Press the PRESET buttons to select “Manual tune”, and press the ENTER button to
confirm.
3.
The display will show the multiplex 5A to 13F.
4.
Press the PRESET buttons to select the channel, and press the ENTER button to confirm.
DAB Display Modes
Every time you press the INFO button on the remote control or press and hold the INFO button on the
unit, the display will show the following display modes: DLS – Programme Type – Ensemble/
Frequency – Signal error/Strength – Bit rate/Codec/Channels – Date