19
AUX operation
There is an “AUDIO IN” socket located at the front of the unit. Analogue audio sound signals from
other sources can be input to the unit through this socket.
1.
Connect the input to another audio device via an AUX cable (not included) with an “AUDIO IN”
socket.
2.
Press the MODE button repeatedly on the unit or press the AUDIO IN button on the remote to
select AUX mode.
3.
Turn the VOLUME +/– dial on the unit or press the VOLUME +/– buttons on the remote control
to adjust the volume control for your desired sound output level.
4. In AUX mode, operate your audio device directly for playback features.
When connecting the external audio device, refer to the owner's manual of the external device.
Sleep Setting
This function allows you to program the unit to turn to standby mode by itself after a set period of
time.
1.
To activate the sleep function, press the SLEEP button repeatedly. The time will change in the
below sequence on every press:
Sleep OFF 15MINS 30MINS 45MINS 60MINS
2.
When your desired sleep time appears in the display, stop pressing the button and the sleep
function will be activated in two seconds. “ ” will show on the display. Also the time remaining
until switch off is displayed next to the symbol in the display.
3.
When the sleep timer counts down to zero, the unit will turn to standby mode. To turn the sleep
function off while the sleep timer is still counting down, press the SLEEP button repeatedly to
select “SLEEP OFF”. “ ” will disappear from the display.
4. Press the SLEEP button once to show the sleep timer status on the display when it is turned on.
Alternatively,
1. Press the MENU button on the remote control to display the function main menu. Press the
PRESET buttons to select Main menu, and then press the ENTER button to confirm.
2.
Press the PRESET buttons to select Sleep mode, and then press the ENTER button to
confirm.
3.
Press the PRESET buttons to select sleep timer, and then press the ENTER button to
confirm.
Setting the Alarm
1.
Press the TIMER button on the remote control, the display shows “Alarm (1 or 2): Off [hh:mm]”.
2.
Press the PRESET buttons to select the Alarm number (1 or 2) and then press the ENTER
button to start the setting of the following parameters.
Press the PRESET buttons to select then press the ENTER button to confirm
To Next Page
Loading...
Need help?
General