16
Prune Invalid
You may remove all unavailable stations from the list.
1.
During DAB mode, press the MENU button and press the PRESET buttons to select Prune
invalid and the press ENTER button to confirm.
2.
Press the PRESET buttons to select YES and press the ENTER button to confirm. Or select
NO to cancel.
DRC (Dynamic Range Compression)
If you are listening to music with high dynamic range in a noisy environment, you may wish to
compress the audio dynamic range.
1.
During DAB mode, press the MENU button and press the PRESET buttons to select DRC
and press the ENTER button to confirm.
2.
Press the PRESET buttons to select DRC high/low/off and press the ENTER button to
confirm the setting.
Station Order
You may wish to arrange the station listing order.
1.
During DAB mode, press the MENU button and press the PRESET buttons to select
Station Order and press the ENTER button to confirm.
2.
Press the PRESET buttons to select Alphanumeric/Ensemble/Valid order and press the
ENTER button to confirm the setting.
FM Operation
Switching from DAB to FM Mode
To switch the unit to FM mode, press the MODE button
repeatedly or press FM/DAB on the remote control the to
switch to FM mode.(F.8) The display will show the frequency.
Auto Scan
(F.8)
FM
radio
- Press the SCAN button to start searching for a station. Once a station has been found, the
scanning will stop automatically.
Alternatively,
- Press and hold the TUNING buttons to start searching for a station.
The search may not stop at a station with a very week signal
Manual Tuning
To search for FM stations manually, press the TUNING buttons repeatedly until your desired
frequency is reached.
With FM radio, it may be necessary to fine tune each station by pressing the TUNING buttons
repeatedly. Each press will adjust the frequency by 0.05 MHz. If reception is still poor, adjust
the position of the aerial or try moving the radio to another location.
To Next Page
Loading...