English
35
Table of settings
If the control system fails unexpectedly, all of the settings should be reset for initial configuration.
In this case, problems are inevitable if all of the setting values are entered in the following table. If
there are questions, this table has to be provided. Only then is a simulation possible to reproduce
the error.
EX ......... factory settings (ex works) CS .......... Controller settings
EX CS EX CS
Basic parameters PAR
Equipment version Program PR 0
Linking of output LO OFF Priority assignm. PA OFF
max1 off °C max1 on °C
max2 off °C max2 on °C
max3 off °C max3 on °C
min1 on °C min1 off °C
min2 on °C min2 off °C
min3 on °C min3 off °C
diff1 on K diff1 off K
diff2 on K diff2 off K
diff3 on K diff3 off K
Subject to change without notice 2016