Technogym Run Forma - Maintenance; Cleaning and Looking After Equipment

23
Run Forma and Spazio Forma
15 Maintenance
!
Warnings
The safety of the equipment is assured only on the condition that it is carefully inspected every two weeks for any signs of damage and/or wear.
Replace defective and worn components immediately, or alternatively remove the equipment from service.
For maintenance actions not described in this manual, call in the Technogym Technical Service.
Cleaning and looking after the equipment
The equipment should always be kept clean and free of dust, in accordance with normal hygiene and sanitary rules.
To clean the control panel, proceed as follows:
- turn the equipment o by switching the switch to 0;
- unplug the equipment power cable from the wall socket;
- clean the control panel with a damp, but not wet, cloth.
Every week, clean the equipment completely:
- with the equipment turned o, clean the external parts with a damp sponge;
- raise the treadmill to the maximum gradient (+12%) and clean around the lower guard and oor with a vacuum cleaner;
- clean the tread surface while it is running, using a clean nylon/synthetic brush or broom.
Do not use chemicals or solvents. Do not use abrasive products on polished parts.
!
Warning
Do not rub too hard on the control panel.