26
Run Forma and Spazio Forma
15.3 Lubricating the treadmill
The equipment is factory-lubricated with products specially designed to have
a long lasting eect. Nevertheless, it may become necessary to replenish
the lm of lubricant between the running track table and the tread belt itself,
especially if the treadmill is used intensively (at high speed and with heavy
users). If the treadmill runs unevenly, slowing down each time the foot comes
down on to the belt, proceed as follows.
Stop the treadmill.
Set the gradient to 12%.
Introduce the spout between the belt and table, as shown in the illustration.
Oil the tread belt in several dierent places, without applying an excessive
amount of oil.
Start the treadmill at a speed of 5 km/h and walk on it for a few seconds.
Stop the treadmill and repeat the above steps four times, so as to cover the
entire surface of the tread belt.
Check that the treadmill now runs smoothly.
If the problem persists, consult the Technogym Technical Support Service.
To Next Page
Loading...
