26
SKILLRUN
TURNING ON AND OFF
To turn the equipment on, move the switch to the ON (I) position. After a quick
system check (reset), the equipment is ready for use.
To turn the equipment o, move the main switch to the OFF (0) position.
The equipment must be switched o only at the end of the exercise, when
in standby.
If the product is not expected to be used for a long time, as well as turning it
o, the plug should also be removed from the wall socket.
Depending on the version of the product, the ON (I) and OFF (0) position may
vary; check the illustration above the switch for the exact position.
W
The switch is used to turn the unit on and off, but does not
fully disconnect it from mains power, even when set to the
OFF (0) position. For complete isolation you must unplug the
power supply plug.
Danger of falling. If the product is not connected to the power
supply, the belt will turn freely. You must hold onto the side
supports when getting on and off the product.
To Next Page
Loading...
