To Next PageTo Next Page
Need help?Do you have a question about the TECHNOLIFT SL-9 and is the answer not in the manual?
Details the key features of the clear-floor, direct-drive two-post lift models.
Provides technical specifications for the SL-9 and SL-9H lift models.
Lists all necessary tools for the proper installation of the lift.
Specifies the required concrete thickness, strength, and condition for safe installation.
Details the minimum power requirements and cable specifications for the lift.
Ensuring the installation site is suitable for the lift, considering concrete, layout, and space.
Using a chalk line to mark the base-plate layout for accurate installation.
Procedure for verifying all components and parts against the shipment list.
Guidance on installing components onto the extension columns as per the diagram.
Instructions for positioning the powerside column based on ceiling height and connection points.
Placing columns, installing anchor bolts, checking plumbness, and adjusting with shims.
Securing the overhead top beam to the extension columns using bolts and connecting brackets.
Connecting the limit switch control bar and limit switch to the lift's electrical system.
Procedure for installing the powerside and offside safety devices on the lift.
Manually lifting the carriages to approximately one meter and ensuring they are locked at the same level.
Connecting the control cables for the low setting configuration of the lift.
Connecting the control cables for the high setting configuration of the lift.
Mounting the hydraulic power unit and connecting the oil hoses to the lift cylinders.
Routing and securing the safety cable as shown in the provided diagrams.
Installing oil hoses and protective covers on the extension and inner columns.
Mounting the lifting arms and properly adjusting the arm lock mechanism.
Connecting the power source, motor wires, and limit switch for single-phase operation.
Wiring diagram and connection steps for three-phase motor electrical system installation.
Visual representation of the SL-9 model with all parts identified for assembly.
Ensuring proper tension for synchronized operation of the lift carriages.
Straining and tightening the safety cable to ensure functionality.
Removing air from the hydraulic system for stable and smooth lift operation.
Modifying the throttle valve to control the descent speed of the lift.
Running the lift with load to verify synchronous operation and safety device function.
Step-by-step guide on safely positioning and lifting a vehicle using the lift.
Procedure for safely lowering a vehicle and preparing it for removal from the lift.
Routine monthly tasks to ensure the lift's safe and efficient operation.
Periodic checks performed every six months for wear, damage, and proper function.
Diagnosing and resolving issues where the motor fails to operate.
Troubleshooting causes for the motor running but the lift remaining stationary.
Addressing problems where the lift fails to maintain its raised position.
Identifying reasons for slow lift operation and potential solutions.
Resolving issues that prevent the lift from lowering.
Comprehensive list of parts with item numbers, part numbers, descriptions, and quantities.
Specific parts related to the oil hose, fittings, and cables for the lift.
List of components specifically for the hydraulic cylinder assembly.
Components for the 220V/50Hz single-phase manual power unit.
Components for the 380V/50Hz three-phase manual power unit.
General| Brand | TECHNOLIFT |
|---|---|
| Model | SL-9 |
| Category | Lifting Systems |
| Language | English |
