Technomark M4 inline - Marking File Columns


Page11sur47

TRAÇABILITÉCRÉATIVE
CREATIVETRACEABILITY
www.technomark-marking.com
Modèle du 29/10/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel : +33 (0) 4 77 22 25 91
Fax : + 33 (0) 4 77 22 38 93
E-mail : info@technomark-marking.com
Usethenavigationarrowstomoveinthetable.Goingdowninanemptylineautomaticallyaddanewone.
Inputsaremadebyanexternalkeyboard.
Herearethedifferentcolumns:
 Line:numberoftheline.Youcan’tchangethisfield.
 :markinglinetextandfunctions.
Textinputsaredonebyanexternalkeyboard.Whenyouareinthisfield,thewholetextisselectandadding
acharacterwillreplacetheentirecurrenttext. 
Tomoveinthefieldtextwithrightandleftarrows,presstheinsertkeyofyourkeyboardandoncemoreto
gooutagain.Usingthearrowsallowstodeselectthewholetextandtomovetheinsertioncursor.

 XandY:Showpositionsofthestartinglinepointwiththechosenunit(mmorinches).
 showtheheightofthelinewiththechosenunit(mmorinches)
Theminimumvalueis0.4mmandthemaximumis200mm.
 Showmarkingfrom1to6(seeMarkingdepth)
 Givesthedotmatrixchosenfrom1to7(seeDotmatrix)
 Givesthecharacterfont:1forthefontOCR,2forthefontOCR‐A
 Givestheangleofthelineindegrees.
Theanglevaluevariesfrom0to360°

 Givesthediameterusedforacircularmarkingwiththechosenunit(mmorinches)
Ifthediametervalueispositive,thebottomofthecharactersisalignedonthecircle.Ifthisvalueisnegative,
thenthetopofthecharactersisalignedonthecircle.
